Conveyor works with pallet jacks

The models 973 and 974 pallet jack interface conveyor are configured with and without squaring arms to align pallets to the centerline. Both offer 3,000 pound maximum load capacity, standard speeds of 40 to 80 feet per minute and a standard 40 x 48 inch GMA or Chep 9-block pallet. To load the conveyor, a pallet jack is driven onto the ramp or plates, lowers the pallet on the plates and backs out. Chains then raise the pallet off the plates and run it onto the next conveyor, eliminating potential conveyor damage. To accommodate the interface, a pit ledge with 26 to 30 inches clearance below ground level is required.

Westfalia Technologies, 3655 Sandhurst Drive, York, PA 17406

Advertisements